Orbital control on cyclical organic matter accumulation in Early Silurian Longmaxi Formation shales     

Siding Jin  Hucheng Deng  Xing Zhu  Yan Liu  Sibing Liu  Meiyan Fu 《地学前缘(英文版)》2020,(2):533-545

High resolution(939 samples)total organic carbon content(TOC)analyses were conducted on the Shuanghe Section of^152.6 m in the Changning area,Sichuan Basin.The sampling section was divided into two units considering the distinct-different deposit environment and sediments accumulation rate.The lower part(Unit 1)and the peer part(Unit 2)with high resolution sample spacing(0.08–0.4 m)enables the identification of the precession cycle in two sedimentary sequences with distinct different sedimentary accumulation rate.MTM Power spectral analyses on untuned TOC series reveals significant peaks exceeding above the 95%confidence level and shows that both Unit 1 and Unit 2 have recorded Milankovitch cycles of 405 kyr long eccentricity,short eccentricity,obliquity and precession.The floating astronomical time scale(ATS)was constructed on the Shuanghe Section in the Early Silurian(~439.673–444.681 Ma),and which was calibrated by 405 kyr long eccentricity cycles.The total duration of the Wufeng and Longmaxi shales is 5.01 Myr.The floating ATS used for estimating the duration of the graptolite zones and each stage in the study interval.Finally,we postulated two models that could verify the linkage between orbital cycle and organic accumulation.To make sure whether productivity or preservation is the main factor that under long eccentricity control,the phase correlation between the obtained filtered signal and the theoretical orbital solution should be made clear in the further research.  相似文献   

花岗岩残积土动态冲击性能的SHPB试验研究     

刘新宇  张先伟  岳好真  孔令伟  徐超 《岩土力学》2020,41(6):2001-2008

为研究花岗岩残积土的动态冲击性能，开展了高速冲击下的分离式霍普金森压杆（SHPB）试验，与常规应变率下的试验结果比较，分析了高应变率对花岗岩残积土的应力?应变特性和强度的影响。结果表明：低、高应变率下的花岗岩残积土的?-?a（轴向应力?轴向应变）曲线均呈现出软化型。随着应变率 增加，?-?a曲线向?a增大的方向移动，破坏应变?af增加。但高应变率下?af增加的程度更加明显。花岗岩残积土的峰值强度普遍具有应变率依赖性，二者可用直线关系拟合，但低、高应变率下的拟合关系并不一致。提出了率敏性因子m定量评价依赖性强弱。研究发现，随着应变率的提高，强度的应变率依赖性减弱，低应变率下的m为26.694，而高应变率下仅为0.013。相关试验结果指出，高速冲击荷载对土体总体有害。工程中应该采取合理措施控制冲击荷载的危害。该研究有助于深化花岗岩残积土动态冲击性能的理解，为相关工程的施工与设计提供技术参考。  相似文献   

2017-08-09新疆精河Ms6.6地震附近区域相对应变的变化分析     

高丽娟  邢喜民  高歌  李尚伟 《大地测量与地球动力学》2019,39(10):1002-1006

2017年精河M_S6.6地震震前，尼勒克、巴伦台和小泉沟台钻孔应变仪记录到显著的应变变化，经现场落实确认，异常是可靠的。根据这3个台的记录资料计算相对应变的变化，结果表明，地震前最大（小）主应变大小和方向分别出现明显加速和急剧偏转变化。此外还发现，相对应变场异常期间主方向与震源机制解P轴方位较为一致。  相似文献   

A novel coupled FDM-DEM modelling method for flexible membrane boundary in laboratory tests     

Hua-Xiang Zhu  Zhen-Yu Yin  Qiang Zhang 《国际地质力学数值与分析法杂志》2020,44(3):389-404

Difficulties are involved in discrete element method (DEM) modelling of the flexible boundary, that is, the membranes covering the soil sample, which can be commonly found in contemporary laboratory soil tests. In this paper, a novel method is proposed wherein the finite difference method (FDM) and DEM are coupled to simulate the rubber membrane and soil body, respectively. Numerical plane strain and triaxial tests, served by the flexible membrane, are implemented and analysed later. The effect of the membrane modulus on the measurement accuracy is considered, with analytical formulae derived to judge the significance of this effect. Based on an analysis of stress-strain responses and the grain rotation field, the mechanical performances produced by the flexible and rigid lateral boundaries are compared for the plane strain test. The results show that (1) the effect of the membrane on the test result becomes more significant at larger strain level because the membrane applies additional lateral confining pressure to the soil body; (2) the tested models reproduce typical stress and volumetric paths for specimens with shear bands; (3) for the plane strain test, the rigid lateral boundary derives a much higher peak strength and larger bulk dilatation, but a similar residual strength, compared with the flexible boundary. The latter produces a more uniform (or ‘diffuse') rotation field and more mobilised local kinematics than does the former. All simulations show that the proposed FDM-DEM coupling method is able to simulate laboratory tests with a flexible boundary membrane.  相似文献   

鄂尔多斯地块周缘垂直形变场负位错反演与应变积累研究     

张希  刘立炜  郝明  白卓立 《大地测量与地球动力学》2019,39(6):551-556

利用鄂尔多斯地块及其周缘1970～2014年的垂直形变速率场资料，借助负位错反演研究该区域长期应变积累。结果表明，地块东北缘山西断陷带中北段年均能量积累增量、剪应力强度都较高，西南缘六盘山断裂与渭河断裂西段次之；山西断陷带中南段至晋陕交界处年均剪应力强度较高且显示一定程度的能量积累；西秦岭构造区尤其西秦岭北缘断裂西段、晋冀蒙交界区也反映一定程度的能量积累特性。  相似文献   

Dynamic modelling of retrogressive landslides with emphasis on the role of clay sensitivity          下载免费PDF全文

Xue Zhang  Scott W. Sloan  Eugenio Oñate 《国际地质力学数值与分析法杂志》2018,42(15):1806-1822

This paper presents a detailed numerical study of the retrogressive failure of landslides in sensitive clays. The dynamic modelling of the landslides is carried out using a novel continuum approach, the particle finite element method, complemented with an elastoviscoplastic constitutive model. The multiwedge failure mode in the collapse is captured successfully, and the multiple retrogressive failures that have been widely observed in landslides in sensitive clays are reproduced with the failure mechanism, the kinematics, and the deposition being discussed in detail. Special attention has been paid to the role of the clay sensitivity on each retrogressive failure as well as on the final retrogression distance and the final run‐out distance via parametric studies. Moreover, the effects of the viscosity of sensitive clays on the failure are also investigated for different clay sensitivities.  相似文献   

对青藏东北缘现今块体划分、运动及变形的初步研究   总被引：19，自引：9，他引：10  

张晓亮  江在森  陈兵  李辉 《大地测量与地球动力学》2002,22(1):63-67

利用2维非连续变形分析方法（DDA），以位移代替围压作为边界约束力，研究青藏东北缘现今块体划分及其运动变形。根据该地区地质构造及地震活动，以GPS点测量位移作为模拟结果约束点，得出了较合理的块体划分模型和随时间演化的主应变分布图，并把应变高值区与近几年来发生的5级以上地震作对比，得出了研究区内地震危险性可能较大的区域。另外，对模拟的甘青块体与阿拉善块体的边缘带断裂左旋运动做了大概计算。  相似文献   

Smeared crack approach: back to the original track     

M. Cervera  M. Chiumenti 《国际地质力学数值与分析法杂志》2006,30(12):1173-1199

This paper briefly reviews the formulations used over the last 40 years for the solution of problems involving tensile cracking, with both the discrete and the smeared crack approaches. The paper focuses on the smeared approach, identifying as its main drawbacks the observed mesh‐size and mesh‐bias spurious dependence when the method is applied ‘straightly’. A simple isotropic local damage constitutive model is considered, and the (exponential) softening modulus is regularized according to the material fracture energy and the element size. The continuum and discrete mechanical problems corresponding to both the weak discontinuity (smeared cracks) and the strong discontinuity (discrete cracks) approaches are analysed and the question of propagation of the strain localization band (crack) is identified as the main difficulty to be overcome in the numerical procedure. A tracking technique is used to ensure stability of the solution, attaining the necessary convergence properties of the corresponding discrete finite element formulation. Numerical examples show that the formulation derived is stable and remarkably robust. As a consequence, the results obtained do not suffer from spurious mesh‐size or mesh‐bias dependence, comparing very favourably with those obtained with other fracture and continuum mechanics approaches. Copyright © 2006 John Wiley & Sons, Ltd.  相似文献   

昆仑山8.1级地震前中国大陆的构造应变背景   总被引：10，自引：4，他引：6  

杨少敏  王琪 《大地测量与地球动力学》2003,23(3):61-65

利用“网络工程”1998～2001年累积的1181个测站的GPS重复观测资料，采用双三次样条函数模型建立中国大陆水平运动模型速度场，用大地坐标在椭球面上计算各类应变场，详细分析了2001年昆仑山8．1级地震前中国大陆水平构造应变场空间分布特征。各类构造应变场的最高值都出现在喜马拉雅构造带与昆仑山地块内(地震断裂带南侧)，鲜水河—安宁河断裂带次之。分析表明，昆仑山8．1级地震正好发生在张性面膨胀应变率的高值区，第一、第二和最大剪应变率高值区边缘的突变区和最大、最小主应变率的高值区。  相似文献   

Strain localization in sand: an overview of the experimental results obtained in Grenoble using stereophotogrammetry     

Jacques Desrues  Gioacchino Viggiani 《国际地质力学数值与分析法杂志》2004,28(4):279-321

Experimental results are presented from the extensive program of drained plane strain compression tests on sand carried out in Grenoble over the last two decades. Systematic analysis of photographs of the deforming specimen allowed for measuring deformations and determining strain fields throughout the test, that is: prior to, at, and after the onset of strain localization. The principles, details and accuracy of the procedure are described, as well as its suitability to properly depict the patterns of deformation. Findings concerning the occurrence and progression of strain localization are discussed. The issues of shear band orientation and thickness are addressed, as well as temporary and persistent complex localization patterns, and the volumetric behaviour inside a band after its formation. The influence of such variables as initial state of the sand (effective stress and relative density), specimen size and slenderness, as well as grain size, is discussed. Copyright © 2004 John Wiley & Sons, Ltd  相似文献